Vehicles under Challenging Climatic Conditions
EDAG Engineering GmbH applies AICON's DPA to measure deformations in a climate chamber
Development partner for technology and sustainability
EDAG, as one of the largest independent development partners in the global automotive industry, knows what it takes to develop leading edge automobiles. The company focuses on overall vehicle development and provides advice and support to its customers from the initial idea through to the finished prototypes. The goal is to find the right solution by using in-house accredited test laboratories that can provide meaningful and validated feedback from real world scenarios at an early stage - for components or whole vehicles, for test systems or material tests, for virtual or real environments. In-house test benches offer customers additional flexibility in vehicle development, as well as in conducting testing and experimental tasks.
Before each measurement, a so-called climate profile is configured. Should temperatures remain stable over a longer period or should there be climatic changes? What are the temperature and humidity at each stage? The exact time of the measurements also needs to be determined and the values compared at the end of the process. A standard measurement lasts 25 days. The object to be measured runs through 50 measuring cycles of 12 hours each. Example of a climatic change: +23 °C, -35 °C, +55 °C and very humid, +80° C and very dry, then back to +23 °C.
Both prototypes and production vehicles are tested. Relevant measuring ranges are material and component transitions, such as the connection between bumper and lights, or bumpers and radiator grilles. Deformations of single points are determined, as well as length and gap deformations.
3D coordinate measurement with hand-held digital camera
For the optical measurement, targets or adapters are placed at all relevant points of the object or vehicle. In addition to simple surface points, a wide range of options is available to signal concealed or inaccessible points. The object is photographed from different directions with the digital camera, so that all significant areas are covered. Simultaneously - or in second step - the digital images are processed in the evaluation computer and the 3D coordinates of the targeted points are automatically calculated.
In the past, EDAG Wolfsburg used standardized calibrated test pins to determine the fitting accuracy of gaps. The precision achieved by this process was no longer sufficient to meet their customers' needs and calls for the application of a photogrammetric system to measure deformation became increasingly insistent. In 2011, EDAG Wolfsburg began to carry our optical measurements with a borrowed DPA. In 2012, the company purchased its own system. Since then, the coordinate measuring machine has proved its worth. Michael Annuß, Team Leader of Environmental Simulation and Endurance Runs at EDAG Wolfsburg, is very satisfied with the choice of AICON: "Deformation analysis, gap measurements - all this is no longer a problem thanks to the DPA. We can now solve our measurement tasks with high precision and speed. The non-contact measurement ensures that the test object is not changed by contact. Our colleagues in Ingolstadt have already been using AICONs DPA for a long time - another advantage, because measurement results within EDAG are compatible."